retfrog.blogg.se

1. #Cant run phd and stellarium telescope control same time how to
2. #Cant run phd and stellarium telescope control same time install
3. #Cant run phd and stellarium telescope control same time mod

Run phd, connect to camera, connect to mount

#Cant run phd and stellarium telescope control same time mod

about 2 months ago i started having the same problem, when i connected to phd after a few minutes the connection froze both with CdC and MaximDL, after a lot of troubleshooting i found that it was the mount's power plug and i made a mod at the power cable and it is permanent at the mount this problem appeared twice in a session about a week ago (i ran the mount at the same battery pack as my laptop) after the mod so if you run the mount from a battery i suggest using a dedicated battery for the mount.Īlso i suggest switching to cartes du ciel since it requires less resources from the pc than stellarium, not to mention that CdC does't use a virtual machine for making the connection to the mount. I think that the crashing problem when you start phd is due to bad power connection of the mount's power plug, also this can be caused by insufficient power. I'm planning on buyin Orions Starshoot Autoguider later, but i guess this also connects to PHD in the same way, so it will be just the same, right? Hopefully someone can feed me with a tea-spoon here, as i feel liek a complete noob on this area with mount control and PHD. Is this the same as the one on the handcontroller, or a separate input? There is an autoguider port on the mount as well, but i have never used this at all. Users should consider switching to the native Stellarium ASCOM option going forward rather than using. There’s no need to use StellariumScope in order to use your ASCOM telescopes with Stellarium anymore. I would like both autoguiding and stellarium to work at the same time. Note that Stellarium supports ASCOM telescopes natively since version 0.19.3. Isn't it so that only one program can access the COM-port at the same time - limiting me to use Either stellarium or PHD? Last season i also got PHD to work, connected also trough the handcontroller - after a lot of messing with the settings though, but anyway.īut my question now is, while i have stellarium connected to the scope trough the handcontroller, can i also connect PHD at the same time? Could someone kindly remind me of the correct steps.

#Cant run phd and stellarium telescope control same time install

I decided to install a newer version of Stellarium and now I can't connect to the telescope using the telescope control plug in.

#Cant run phd and stellarium telescope control same time how to

I've finally understood how to connect my scope to stellarium, and tested it very quickly - seems to be working fine Hello, Previously I have had no problems using Stellarium and eqmod with my EQ6. Not sure if this shuold be in this category or software - but i try here.